AeroCheck 3

 

• Rotary Drive C-Scan capabilities as standard.
• Industry standard probe connectors.
• User friendly interface, single level menu system, “quick function” sidebar.
• Large, daylight readable display 145mm (5.7”). 
• Rugged ergonomic overmoulded housing, lightweight 1.15kg (2.54lbs)
• Up to 10 hours battery life (pencil probe), 7 hours (rotary drive).
• Charging time of 2.5hrs, simultaneous charge and operation.
• 3 year standard warranty
• Optional EThercover extending warranty to 6 years.

Rotary inspection C-Scan capabilities 

The new high resolution C-Scan feature gives an image of the inner diameter hole inspection. This image allows the individual layers in an inspected hole to be visualised. The data collected can be stored as a full data array with up to two frequencies. Further analysis both on the instrument and offline on a desktop PC is possible. Stored data may then be further analysed and optimised with the Gain and Phase being fully adjustable post-test, which significantly increases the probability of detection and improve data interpretation. Up to 10,000 scans may be stored on the 32GB SD card.

Auto-Mix

Simplifies the sometimes complex procedure of mixing two different frequency signals, which can be achieved on the AeroCheck+ through a series of easy steps. Setting the Auto-mix itself is as simple as pressing one key.

Innovative “Loop” Feature

“Loop” is a convenient way of capturing a live repetitive signal and then adjusting the instrument settings especially Phase, Gain and Filters in order to simplify the task of optimizing the parameters.

“Guides” Feature

"Guides" allow the user to display a slide show that can be created easily with commonly used desktop software. The benefit of this feature is that instructions, tutorials and procedures for the inspection can be added to the AeroCheck+ very quickly and the NDT inspector can easily switch between the Inspection itself and the “Guides” while performing a live test.

Trace

The trace function allows a reference waveform to be stored on the screen and appears along with the graticule behind the live spot. This allows the operator to readily compare the live data with the reference calibration.

Operator defined “soft keys”

There are four soft key positions for operator selectable icons for frequently used functions and a fifth position for the last menu function used. Each saved instrument setting can be associated with a unique, one press set of quick access functions. There are also two front panel hard keys that can also be easily programmed for rapid one press access to instrument functions.

Industry standard probe connectors

All of the probe connections on the AeroCheck 3 are IP68 rated which further enhances the adaptability of this flaw detector across industrial sectors.  

Probe socket LEMO 12-Way 2B (IP68): Absolute, Bridge, Reflection and Conductivity.

Probe socket LEMO Coax OO (IP68): Absolute.

AeroCheck 3 Kit (Keypad Option) : KIAER300

AeroCheck 3 Kit (Thumbwheel Option) : KIAER300TW

• 

  Dual Frequency/Channel feature

  At different frequencies, different signal indications (e.g. lift off and defect) have a different relative phase and amplitude response. By means of Phase rotation and Gain change of the X Y signal components one of these indications can be manipulated to be almost identical in phase and amplitude as the other and then by subtraction (mixing), the unwanted component is minimised, giving an improved detection of the required signal.

• 

  Conductivity Measurement

  When connecting  the Conductivity Probe, the WeldCheck 3 auto-detects the probe and seamlessly switches into conductivity mode. The Conductivity Measurement Option is available through the purchase of the KACON001 KIT.

• 

  Trace Feature

  The trace function allows a reference trace to be stored on the screen and appears along with the graticule behind the live spot, allowing the operator to readily compare the live data with the reference calibration.

AeroCheck 3 Brochure (1.1MB)