EmbedEC - Embedded Eddy Current NDT Solution

 

EmbedEC is ideal for integrating Eddy Current into an automatedEmbedECRangeCutoutreduced system to provide a solution to varied applications such as: 

• Surface breaking defects detection. 

• Sub-surface defects detection in non-ferrous materials. 

• Heat Treatment/Material property verification. 

• Sensing applications for verifying geometry such as the presence of threads, butt-weld detection etc. 

The EmbedEC has been designed with the needs of the engineer in mind featuring Analogue outputs and SPI and USB remote control/data streaming for Control System Integration. It’s possible to stream real time data and a DLL is available to permit software integration by the end user.

  • Single Channel. 

    Displayless. 

    Available as Printed Circuit Board or in enclosure with USB connector and analogue outputs. 

    Small footprint. 

    USB or SPI control. 

    Dual Analogue Outputs on SPI Card Version. 

    Data streaming over SPI/USB. 

    Powered By 5v DC or USB for Easy Integration in an Industrial Control System. 

    DLL available to facilitate software integration. 

  • Surface breaking defects detection. 

    Sub-surface defects detection in non-ferrous materials. 

    Heat Treatment/Material property verification. 

    Sensing applications for verifying geometry such as the presence of threads, butt-weld detection etc. 

Probe  Connector 1 off 6 Way  (50 ohm Bridge or Reflection only) 
Frequency      Single Freq. 50 Hz to 5 MHz
Gain Overall  0 to + 82 dB
Main Gain 0 to +76dB, 0.1dB steps
Input 12dB
Drive 0dB or 6dB (0dB reference 1mW into 50 ohm)
Max X/Y Ratio 0dB to 76dB independent
Phase Range 0.0-359.9°, 0.1° steps
Filters High Pass DC to 2kHz Low Pass Filter in 1 Hz steps. 
Low Pass 3Hz to 4kHz in 1 Hz steps.
Connectivity PC Board Version SPI with PC remote control slave mode Outputs of X and Y range -1 to +1 v (Board version only)
USB Version  Virtual Com Port remote control plus Real Time data streaming
EmbedEC+ 5 Configurable Digital Input Output Lines may be  for up to 2 Encoders up to 2 and Alarm Out or I2C connection)
Verification Level The system includes on delivery a 2 year validity Verification Level 2 detailed functional check and calibration as as per ISO 15548-1:2013 
Power External 5 v DC or over USB 125mA
Physical PC Board Version Weight 75 g / 2.6 ounces
Dimensions 60 x  100 mm / 2.25 x 4.0  inches
USB Verion No I/O Weight 275 g / 10 ounces
Dimensions 125*80*45 mm / 4*3.2*1.8 inches
USB Version with I/O Embed EC+ Weight 225g / 8 ounces
Dimensions 125*80*32 mm / 5*3.2*1.25  inches
Operating Temp. -40 to +85 °C
Storage Temp. Storage for up to 12 months -20 to +35 °C Nominal +20 °C
 IP Rating None

If you have any questions regarding the EmbedEC Eddy Current Embedded Solution, please feel free to contact a member of the team at sales@ethernde.com